Capacity Decay in LiNiO2: An Atomistic Kinetic Picture

23 December 2024, Version 2
This content is a preprint and has not undergone peer review at the time of posting.

Abstract

High-Ni layered oxides experience significant capacity decay over cycling, but the underlying mechanisms remain controversial. Using atomistic simulations, the electrochemical behavior of the fatigue phase is reproduced: a surface densified phase traps the last 25% of Li the end of charge, while discharge remains unimpeded. When the Li content falls to 25%, the remaining Li are locked into a superlattice, making the creation of vacancies the rate-limiting step for further delithiation. After cycling, the surface densified phase resembles Ni5O8 , with 25% Ni in the Li layer forming a similar superlattice. These Ni pin nearby Li, suppressing vacancy formation at the surface and kinetically trapping Li inside. Meanwhile, the Ni5O8 phase exhibits high diffusivity for Li interstitials in the superlattice, which explains the minimal resistance increase during discharge at the same Li content. Further densification leads to a surface phase that hinders both charge and discharge across the entire voltage range.

Keywords

Ni-rich layered oxide
fatigue phase
capacity decay
Li-ion battery
kinetics

Comments

Comments are not moderated before they are posted, but they can be removed by the site moderators if they are found to be in contravention of our Commenting Policy [opens in a new tab] - please read this policy before you post. Comments should be used for scholarly discussion of the content in question. You can find more information about how to use the commenting feature here [opens in a new tab] .
This site is protected by reCAPTCHA and the Google Privacy Policy [opens in a new tab] and Terms of Service [opens in a new tab] apply.