An Economic Fluorescent Method for Microplastics Detection in Soil Samples

17 October 2024, Version 2
This content is a preprint and has not undergone peer review at the time of posting.

Abstract

Microplastics from urban and industrial waste are threatening ecosystems worldwide. Quantification methods for soil samples have been proposed but typically require complex and expensive laboratory procedures, which are not accessible to the public. Therefore, we developed a simplified Nile red fluorescent dye method with low-budget materials that can be readily used as lone-standing demonstrations or implemented in environmental education modules. The method was validated on commercial coarse-grain sand spiked with microplastics (1-5 mm). Following incubation with Nile red dye, the analytes were visually inspected using blue light and orange filter glasses and counted by two independent masked assessors. Detection of particles was close to 100 percent. Four different types of environmental analytes were subsequently tested with this method: urban lake shore sediment, agricultural soil, gardening soil, and soil from a state park. Urban lake shore and garden soil samples showed the highest density of microplastic particles. Large numbers of smaller particles (<1 mm) were also identified and counted in these analytes, with very good reproducibility by the same assessor and replication of the rank order of analytes between two assessors. Visualizing microplastic pollution with this low-cost, scalable method can reach broad sections of educational settings and the broader public and thus raise awareness of the problem of microplastic pollution.

Keywords

Microplastic detection
soil
sediment
fluorescent dye method
low-cost

Supplementary materials

Title
Description
Actions
Title
Materials and spectra
Description
Table S1. Materials, sources, and costs* for the simplified fluorescent microplastic detection method Figure S1: Spectra of four particles analysed by Fourier-transform infrared spectrophotometry, a,b) polyethylene, and (c,d polystyrene (Veerasingam et al., 2021)
Actions

Comments

Comments are not moderated before they are posted, but they can be removed by the site moderators if they are found to be in contravention of our Commenting Policy [opens in a new tab] - please read this policy before you post. Comments should be used for scholarly discussion of the content in question. You can find more information about how to use the commenting feature here [opens in a new tab] .
This site is protected by reCAPTCHA and the Google Privacy Policy [opens in a new tab] and Terms of Service [opens in a new tab] apply.