Optimizing reaction conditions for the light-driven hydrogen evolution in a loop photoreactor

08 December 2023, Version 4
This content is a preprint and has not undergone peer review at the time of posting.

Abstract

Photocatalytic hydrogen production from water is a promising way to fulfill energy demands and attain carbon emission reduction goals effectively. In this study, a loop photoreactor with a total volume of around 500 mL is presented for the photocatalytic hydrogen evolution using a Pt-loaded polymeric carbon nitride photocatalyst under 365 nm irradiation in the presence of sacrificial reducing agents. The fluid flow pattern of the developed photoreactor was characterized experimentally and the photon flux incident to the loop photoreactor was measured by chemical actinometry. The system displayed exceptional stability, with operation sustained over 70 hours. A Design of Experiment (DOE) analysis was used to systematically investigate the influence of key parameters - photon flux, photocatalyst loading, stirring speed, and inert gas flow rate - on the hydrogen generation rate. Linear relationships were found between hydrogen evolution rate and photon flux and inert gas flow rate. Photocatalyst loading and stirring speed also showed linear correlations, but could not be correctly described by DOE analysis. Instead, linear single parameter correlations could be applied. Notably, the loop photoreactor demonstrated an external photon efficiency up to 17 times higher than reported in literature studies, while scaling the reactor size by a factor of 10.

Keywords

Loop photoreactor
Parametric study
Photocatalytic water reduction
Polymeric carbon nitride
Solar energy storage

Supplementary materials

Title
Description
Actions
Title
Supporting_Information_File_1
Description
Details of CAD drawing, technical specification, adjustment factor calculation, and DOE table.
Actions
Title
Supporting Information File 2
Description
Videos from fluid flow characterization.
Actions
Title
Supporting Information File 3
Description
Python code for video processing to get mixing time.
Actions
Title
Supporting Information File 4
Description
.STL files of the 3D-printed parts.
Actions

Comments

Comments are not moderated before they are posted, but they can be removed by the site moderators if they are found to be in contravention of our Commenting Policy [opens in a new tab] - please read this policy before you post. Comments should be used for scholarly discussion of the content in question. You can find more information about how to use the commenting feature here [opens in a new tab] .
This site is protected by reCAPTCHA and the Google Privacy Policy [opens in a new tab] and Terms of Service [opens in a new tab] apply.